James D. Meadows
Complete Set:
$1994.64

Geometric Dimensioning & Tolerancing Complete Course

10 Hour Lecture from the Two and a half day course on Geometric Dimensioning & Tolerancing

Session 1: Introduction to GD&T and the Basic Principles
Session 2: Mating Part Tolerancing and Boundaries
Session 3: Tolerancing Rotating Parts in an Assembly
Session 4: Geometric Characteristic Symbology
Session 5: Mating Part Tolerancing Formulas and their Application
Session 6: Flexible Parts, Free State Variation, Restrained vs. Free State Measurement, Sheet Metal, Plastic & Rubber Parts, Positional Boundary Concept & Datum Targets
Session 7: Tolerancing Complex Mating Parts
Session 8: Composite Position and Profile Tolerancing vs. Two Single-Segment Controls, Three-Level Composite and Combined Controls

James D. Meadows
Complete Set:
$991.20

Tolerance Stack-Up Analysis series

5.6 Hours of Lecture from the two and a half day lecture on Tolerance Stack-Up Analysis

#1 The Basics
#2 Stack-Up Analysis of an Eleven Part Assembly Using Plus and Minus Tolerancing
#4 Assemblies with Plus and Minus Tolerances
#5 Floating Fastener Five Part Assembly Analysis
#6 Fixed Fastener Assemblies
#7 A Rail Assembly
#8 Single-part Analysis
#9 Five Part Rotating Assembly Analysis
#10 Trigonometry and Proportions in Tolerance Stack-Up Analysis
#11 The Theory of Statistical Probability

If you have any questions about GD&T training, books, workbooks, tests or DVDs, please reach out to James D. Meadows & Associates, Inc., at (615) 924-3600, or manually email at jim@geotolmeadows.com