Your Success Begins with Quality Training and Education phone(615) 924-3600
GD&T Specialists
  index about training public workshops store contact  

 

Geometric Dimensioning & Tolerancing Complete Course

 

GD&T set

   James D. Meadows

Complete Set: $1994.64

10 Hour Lecture from the Two and a half day course on Geometric Dimensioning & Tolerancing

Session 1: Introduction to GD&T and the Basic Principles
Session 2: Mating Part Tolerancing and Boundaries
Session 3: Tolerancing Rotating Parts in an Assembly
Session 4: Geometric Characteristic Symbology
Session 5: Mating Part Tolerancing Formulas and their Application
Session 6: Flexible Parts, Free State Variation, Restrained vs. Free State Measurement, Sheet Metal, Plastic & Rubber Parts, Positional Boundary Concept & Datum Targets
Session 7: Tolerancing Complex Mating Parts
Session 8: Composite Position and Profile Tolerancing vs. Two Single-Segment Controls, Three-Level Composite and Combined Controls

Geometric Dimensioning & Tolerancing Complete Course

 
 
 

If you have any questions about GD&T training, books, workbooks, tests or DVDs,

please reach out to James D. Meadows & Associates, Inc., at (615) 924-3600. 

 
© 1997 -   James D. Meadows & Associates, Inc., ALL RIGHTS RESERVED Site Design & Maintenance by VIRTUAL GOLDMINE